Home » SONAX scratch remover paint action set

SONAX scratch remover paint action set

In stock
SKU: 20033151
No reviews
CHF 25.90

Product details

  • SKU 20033151
  • Barcode 4064700305847

Would you like to recommend the product?
Easily share it on your social media channel by clicking here:

Description Shipment
  • Scratch remover paint action set
  • Cost-effective manual removal
  • Removal of local scratches, scuffs or traces of paint from clear coat
  • For all colored & metallic as well as scratch-resistant paints

Set for the cost-effective manual removal of local scratches, scuffs or traces of paint from clear varnish. Even deep scratches can be removed in just a few steps, as long as they do not extend to the base coat or primer. For all colored & metallic as well as scratch-resistant paints. CONTENTS: 25 ml Polish 1, 25 ml Finish 2, 4 sanding pads, 2 polishing fleeces and 1 polishing stamp.

At a glance :

  • Manual removal of local scratches, scuffs or traces of paint from clear coat
  • Even deep scratches can be removed in just a few steps
  • For all colored & metallic as well as scratch-resistant paints

Application :

  1. Before starting, wash the area to be treated with shine shampoo.
  2. SANDING: Depending on the depth of the scratch, sanding may be necessary. To do this, stick one of the included sanding pads under the polishing stamp, moisten the paint with water and sand in a circle over the scratch with light pressure. Do not sand down to the primer and do not tilt! Then sand the residue with the enclosed polishing fleece  wipe off. A dull spot remains. DANGER! Sanding is only necessary for deep scratches. Many scratches and scrapes can be repaired without this step.
  3. PRE-POLISHING: Apply Polish 1 to the scratched or already sanded area. Wrap the polishing stamp with a clean polishing fleece. Then polish the sanded or scratched area with high pressure until the scratches or traces of sanding are no longer visible. Depending on the density or depth of the scratch, this may take a few minutes. If the polishing area becomes too dry, apply Polish 1 again. Then wipe off any polishing residue with a polishing fleece.
  4. FINISH: Apply Finish 2 to the pre-polished area. Wrap a new, clean area of ​​the polishing fleece (as previously described) around the polishing stamp and rub with medium pressure until the desired surface shine is achieved. Finally, wipe off any residue with a polishing fleece.

Notes :

  • Do not use in the sun or on hot rims
  • Do not let it dry
  • Protect product from frost